December 26, 2009 127 min Sat study bcmsn exam prep... 2100 – 2300 next: more bcmsn exam prep...

December 27, 2009 360 min Sun study bcmsn exam prep... 1200 – 1800 next: more bcmsn exam prep...



worked 4 hours on stretch lab and did write up on it here......

My Home Lab

I have my home practice lab set up here on my desk at work. One 2600 router on the bottom. One 2500 router sitting on the top. One dte/dce serial interface cable.

Also have a USB Ethernet NIC plug adapter and am able to connect these two routers to my GNS3 dynamips routers.

Now the same problem is back on my 2500. I think this router is dying on me.

Now my 2600 router comes up in rommon 1> mode. Wonder what's up with that.

I have a Cisco 2500 router and I can't get it to boot up. It was working fine and now all of a sudden it won't boot up. I saw it go in to rommon> mode and then I just rebooted it and now it gets stuck on boot up.

I tried to hit ctrl-break to get into rommon mode within 60 seconds of powering down and back on. It gets the > prompt but no response from any keys at that prompt.

Anybody have any ideas. I think the router is shot and is now hazerdous waste.



click to imbiggen.

I think this is the message that might have a clue in it.

%SYS-4-CONFIG_NEWER: Configurations from version 11.2 may not be correctly understood.

This is what it looks like if I don't hit ctrl-break to try to get in to rommon mode. It's gets this far but no farther. It gets stuck right here.



Also posted at PacketLife community lab forum here.

Update: Now it's working. Never mind.